Logo

C0077 Engine Code Repair

Meaning of C0077 engine trouble code is a kind of chassis trouble code and when the check engine light comes C0077 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.

C0077 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for C0077 code is occuring now you should check C0077 repair processes.
Now don't ask yourself; What should you do with C0077 code ?
The solution is here :

C0077 Possible Solution:

C0077 Engine

Excessive air inflow can be caused by a vacuum leak, a dirty sensor or, an exhaust gas recirculation valve not closing properly. If the problem is not enough fuel, the culprit may be dirty injectors or fuel filters, a weak fuel pump or a leaky fuel pressure regulator. The lean fuel mix error may be accompanied by rough idling, engine misfires, hesitation during acceleration and overall poor engine performance.

C0077 Code Meaning :

C
OBD-II Diagnostic Chassis (C) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

0
Injector Circuit Malfunction - Cylinders

7
Cylinder 4 Contribution/Balance Fault

7
Ignition Coil A Primary/Secondary Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C0077 OBD-II Diagnostic Chassis (C) Trouble Code Description

C0077 engine trouble code is about Ignition Coil A Primary/Secondary Circuit Malfunction.

Main reason For C0077 Code

The reason of C0077 OBD-II Engine Trouble Code is Injector Circuit Malfunction - Cylinders.

Parts or components should not be replaced with reference to only a C0077 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.